How to operate MAZAK 400 II milling machine?
Written by Josh on June 30, 2009 – 5:32 pm -
MAZAK 400 II is a machine controlled Numericaly computer and I want to know him operate or use the controlled relief.
Posted in FAQs |
MAZAK 400 II is a machine controlled Numericaly computer and I want to know him operate or use the controlled relief.
Posted in FAQs |
By CT on Jul 1, 2009 | Reply
Call Mazak in Florence Kentucky programs and a class.
By TD on Jul 4, 2009 | Reply
Read the manual
By gwhatch2001 on Jul 7, 2009 | Reply
Based on the stores where I calibrated CMM 's who raised standing around and yelled through the factory all'idiota the other side. They have worked seriously on the programming language of DMIS.
By Vishal Warialani on Jul 10, 2009 | Reply
you can specify that the regulator is using in this CNC ….. according to the regulator will have to write the program and then load them on the ground of contoller.
By beedaduck on Jul 11, 2009 | Reply
You have to learn colloquial programming for the machine. It consists of "common G" codes that tell the machine what to do. I know of with an Okuma but I have not worked Mazak / Fanuc. Each regulator has it 's owns the whims. This link shows the common codes used Example G00 - is a common code used to the rapid machine to a point, say that (G00 X2.00 Y2.00)-G01 is a rate of entry for cutting G73 is a common code of drill (G73 X2.0 Y2.0 Z-1.0 S1200 M3 M53 F6) S-Alberini RPM M3 - Light post M53 - Skip the HEIGHT F - RATE OF ENTRY These are just some of them to get started. There are also macros that you can program in complex operations. The best way is to show someone how to plan and write your own and put them in place. My apprentices are usually write programs from prints by itself in a matter of weeks. Hope that this help a bit.