can you help me about error in control machine cnc?
Written by Josh on February 22, 2009 – 8:55 am -
I have a CNC milling machine from Mitsubishi MELDAS (300). on this mashine battery is low then parmeter is lost. thus changing the battery and enter the parameter () user and machine. but not the parameter to the control system have input axis 6. but my car has axis 3. so if you can help. thanks.
Tags: Axis, Mitsubishi, System Parameter
Posted in FAQs |
By stratsandlespauls on Feb 23, 2009 | Reply
Your question is confusing, if you have 3 axis then that you would not have been able to schedule more than 3.
By pplsag on Feb 23, 2009 | Reply
First off, studies the ability to convince a technical service of CNC, to look inside the car / propblem. Selo put in touch with if you need a list of people I know. After the call and send electronic mail to technical support staff for the HQ of the USA Mitsubish Later, controls all tie in your locker electricity when power is switched off and ensures that they are close. If you're not sure, remove their wires, shot and puliscali if dirt, then re-engaged them